Filter
Top Products
FC-210/310 ADJUSTMENT 2 - 12 February 2002 © TOSHIBA TEC
2.5.2 Registration motor speed adjustment
The paper transport speed of the registration roller vis-a-vis the image pirnt speed can be set to the
optimum value.
<Procedure>
(1) While pressing the digital keys [0] and [5] simultaneously, turn the power ON. ৎ (Adjustment mode)
(2) Set five sheets of A4-R /LT-R paper into the bypass tray.
(3) Enter [10] and press the [PRINTER/NETWORK] key to perform the continuous printing of five
“adjustment charts” from the bypass tray.
(4) Since the printed sheets of “adjustment charts” are slightly shrunk after being fused, it it required to
wait one to two minutes to cool them for precise adjustment. Then, set those five sheets again into
the bypass tray in the same print direction, with the chart face upward.
(5) Without changing the adjustment mode , enter [406] and press the [START] key.
While the “adjustment chart” sheets are fed and transported, the pitches in the black belt zone are
read.
(6) Step (5) is to be repeated five times automatically.
The displayed set value does not change until the fourth round and at the fifth round, a newly set value
is displayed.
(7) When a newly set value for aligning is displayed at the fifth round, press the [INTERRUPT] key to
update the set value.
If error or jam occurs when feeding the adjustment charts, press the [CLEAR] key and perform step
(2) to step (7) again.