Filter
Top Products
FC-210/310 PREVENTIVE MAINTENANCE 3- 2 February 2002 © TOSHIBA TEC
3. 2 Outline of the Maintenance Order
(1) Preparation
a. Discuss current machine conditions with the key operator and note them down.
b. Before starting maintenance, make a few sample copies by TCC-1 chart and keep them for later
reference purposes.
c. Turn OFF the power switch, and be sure to unplug the copier.
(2) Perform preventive maintenance following the checklist shown below. During maintenance, refer to
the illustrations attached and the Service Manual as required.
(3) After having finished the maintenance, plug in the copier, turn ON the power switch, and make a few
copies to confirm that the copier is working normally.
3. 3 Preventive Maintenance Checklist
Symbols used in the checklist
Cleaning Lubrication Replacement Operation check Date
A Cleaning with alcohol
Cleaning with soft pad,
cloth or vacuum cleaner
W White grease
(Molykoat)
AV Alvania No.2
Values indicate the
replacement cycle.
(Value x 1000 sheets)
Replace if
deformed or
damaged
After cleaning
or replacing,
check for no
abnormality.
User’s name
Serial No.
Inspector’s
name
Remarks
Notes: 1. Values under “Cleaning” and “Replacement” indicate the cleaning and replacement cycles for the FC-
210/310.
2. Lubricate every 40,000 sheets for FC-210 and 60,000 sheets for FC-310. Lubricate to the replacement
parts according to the replacement cycle.
3. Do not stain any oil on the rollers, belts and belt pulleys.
4. The replacement cycle of the parts in the feeding section depends on the number of sheets fed from
each paper source.
5. <P-I> under “Remarks” indicates page and item number in the Parts List.