Filter
Top Products
February 2002 © TOSHIBA TEC 2 - 3 FC-210/310 ADJUSTMENT
(6) After all developer materials are removed and "READY" is displayed, turn the power OFF.
Time required for removing Color developer materials only : Approx. 6 min.
Developer material K only : Approx. 3 min.
(7) Open the front cover and take out the processing unit (EPU). Turn the knob of the developer removal
shutter back to the center position.
(8) Return the processing unit (EPU) to the copier and close the front cover.
2.2.2 Initialization of the auto-toner senor
Note: This procedure shall be carried out when no developer material is filled in the processing unit
(EPU). If material has been filled, follow the procedure of developer material removing in the
previous heading.
(1) Open the front cover to install the developer cartridge(s) and then close the front cover.
(2) Turn ON the power while digital keys [0] and [5] are pressed simultaneously to dispaly the following
screen.
[0] [5]
100% A A3
[POWER] ৎ TEST MODE
(3) Enter a code with digital keys and press the [START] key.
Code 200 : All developer materials 204 : Developer material K only
221 : Color developer materials only
100% 200 A3
(Code) ৎ [START] ৎ TEST MODE
(4) When the copier starts operating, a message “WAIT” is shown and the developer material filling starts
(approx. 3 min.).
WAIT