Filter
Top Products
FC-210/310 TROUBLESHOOTING 4 - 18 February 2002 © TOSHIBA TEC
[EAB] Saddle stitcher transport stop jam
Is there any paper remaining on the transport path in the finisher, saddle stitcher section or copier?
YES
Remove the paper.
NO
Is either of the connectors J10 or J9 on the saddle stitcher controller PC board disconnected?
Is any of the harnesses connecting between the saddle stitcher controller PC board and sensors
(No.1 paper sensor (PI18S), No.2 paper sensor (PI19S), No.3 paper sensor (PI20S) and delivery
sensor (PI11S)) open-circuited?
YES
Connect the connector securely. Replace the harness.
NO
Are the No.1 paper sensor, No.2 paper sensor, No.3 paper sensor and delivery sensor functioning
properly? (Do the actuators return normally?)
NO
1. Connect the connectors of the sensors securely.
2. Attach the actuators if they have come off.
3. Replace the sensors.
YES
Replace the saddle stitcher controller PC board.
[EAC] Saddle stitcher transport delay jam
Is there any paper remaining on the transport path in the finisher, saddle stitcher section or copier?
YES
Remove the paper.
NO
Is any of the connectors J6, J9 and J10 on the saddle stitcher controller PC board disconnected?
Is any of the harnesses connecting between the saddle stitcher controller PC board and the sensors
(No.1 paper sensor (PI18S), No.2 paper sensor (PI19S), No.3 paper sensor (PI20S), delivery sensor
(PI11S), and paper positioning plate paper sensor (PI8S)) open-circuited?
YES
Connect the connector securely. Replace the harness.
NO
Are the No.1 paper sensor, No.2 paper sensor, No.3 paper sensor, delivery sensor, and paper
positioning plate paper sensor functioning properly? (Do the actuators return normally?)
NO
1. Connect the connector of the sensor securely.
2. Attach the actuator if it has come off.
3. Replace the sensor.
YES
Replace the saddle controller controller PC board.