Filter
Top Products
February 2002 © TOSHIBA TEC 4 - 5 FC-210/310 TROUBLESHOOTING
[E13] Paper misfeed from the 1st cassette
[E14] Paper misfeed from the 2nd cassette
[E15] Paper misfeed from the 3rd cassette
[E16] Paper misfeed from the 4th cassette
Open the side door; does any paper remain in the paper path from the cassette?
Remove the paper.
Is the width of the side guide set too narrow for the paper width?
Set the side guide wider.
(When the tray is being lifted, make sure that a gap is left between the paper and
the side guide.)
Is the harness between the LGC board and the cassette feed-jam sensor open-circuited?
Is the cassette feed-jam sensor connector or the connector J106 or J107 on the LGC board
disconnected?
Reconnect the connector. Replace the harness.
1. Replace the cassette feed-jam sensor.
2. Replace the LGC board.
[E19] Paper misfeed from the LCF
Open the side door; does any paper remain in the paper path from the LCF?
Remove the paper.
Is the harness between the LGC board and the cassette feed-jam sensor open-circuited?
Is the cassette feed-jam sensor connector or the connector J105 or J107 on the LGC board
disconnected?
Reconnect the connector. Replace the harness.
1. Replace the cassette feed-jam sensor.
2. Replace the LGC board.
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO