Filter
Top Products
194 AT-TQ2403 - Management Software - User's Guide
CLI
Command
Description
set The "set" command allows you to set the property values of existing instances of a class.
set unnamed-class [ with qualifier-property qualifier-value ... to ] property
value . . .
The first argument is an unnamed class in the configuration.
After this is an optional qualifier that restricts the set to only some instances. For
singleton classes (with only one instance) no qualifier is needed. If there is a qualifier, it
starts with the keyword with, then has a sequence of one or more qualifier-property
qualifier-value pairs, and ends with the keyword to. If these are included, then only
instances whose present value of qualifier- property is qualifier-value will be set. The
qualifier-value arguments cannot contain spaces.
Therefore, you cannot select instances whose desired qualifier-value has a space in it.
The rest of the command line contains property-value pairs.
set named-class instance | all [ with qualifier-property qualifier-value ... to ]
property value . . .
The first argument is either a named class in the configuration.
The next argument is either the name of the instance to set, or the keyword all, which
indicates that all instances should be set. Classes with multiple instances can be set
consecutively in the same command line as shown in Example 4 below. The
qualifier-value arguments cannot contain spaces.
Here are some examples,
1. set interface wlan0 ssid "Vicky's AP"
2. set radio all beacon-interval 200
3. set tx-queue wlan0 with queue data0 to aifs 3
4. set tx-queue wlan0 with queue data0 to aifs 7 cwmin 15 cwmax 1024 burst 0
5. set bridge-port br0 with interface eth0 to path-cost 200
Note: For information on interfaces used in this example (such as wlan0, br0, or eth0)
see “Understanding Interfaces as Presented in the CLI
”.