Filter
Top Products
94 AT-TQ2403 - Management Software - User's Guide
Field Description
Static IP Address If you chose Static IP as the Connection Type, these fields will be
enabled.
Enter the Static IP Address in the text boxes.
Subnet Mask Enter the Subnet Mask in the text boxes. You must obtain this
information from your ISP or network administrator.
Default Gateway Enter the Default Gateway in the text boxes.
DNS Nameservers The Domain Name Service (DNS) is a system that resolves the descriptive
name (domainname) of a network resource (for example,
www.alliedtelesis.com) to its numeric IP address (for example,
66.93.138.219). A DNS server is called a Nameserver.
There are usually two Nameservers; a Primary Nameserver and a
Secondary Nameserver. You can choose DNS Settings via DHCP:
If you choose
On, the IP addresses for the DNS servers will be
assigned automatically via DHCP. (This option is only available if you
specified DHCP for the Connection Type).
If you choose Off, you should assign static IP addresses manually.
DNS Domain Specifies a local domain name for use as the default domain.
The DNS Domain can be up to 63 characters long.
Configuring Guest Interface Ethernet (Wired) Settings
To configure Ethernet (Wired) Settings for the "Guest" interface, fill in the fields as described below.
Field Description
MAC
Address
Shows the MAC address for the Guest interface for the Ethernet port on this access
point. This is a read-only field that you cannot change.
VLAN ID If you choose to configure Internal and Guest networks by "VLANs", this field will be
enabled. (Provide a number between 1 and 4094 for the Guest VLAN.)
Subnet Shows the subnet work address for the Guest interface. For example, 192.168.1.0.
Updating Settings
To update Ethernet settings:
1. Navigate to the Ethernet (Wired) Settings page.
2. Configure the Ethernet settings as required.
3. Click the Update button to apply the changes.