Filter
Top Products
28 AT-TQ2403 - Management Software - User's Guide
Review / Describe the Access Point
Figure 7: Basic Settings Page Step 1
Field Description
IP Address Shows IP address assigned to this access point. This field is not editable
because the IP address is already assigned (either via DHCP, or statically
through the Ethernet Settings page as described in “Configuring Guest
Interface Ethernet (Wired) Settings
”).
MAC Address Shows the MAC address of the access point.
A MAC address is a permanent, unique hardware address for any device
that represents an interface to the network. The MAC address is
assigned by the manufacturer. You cannot change the MAC address. It is
provided here for informational purposes as a unique identifier for an
interface.
The address shown here is the MAC address for the bridge (br0). This is
the address by which the AP is known externally to other networks.
To see MAC addresses for Guest and Internal interfaces on the AP, see
the Status > Interfaces ta
b.
Firmware Version Version information about the firmware currently installed on the access
point.
As new versions of the AT-TQ2403 Management Software firmware
become available, you can upgrade the firmware on your access points to
take advantages of new features and enhancements.
For instructions on how to upgrade the firmware, see “Upgrading the
Firmware
”.
Time since system-up It is to show the passed time since system boot up.