Filter
Top Products
AT-TQ2403 Management Software User's Guide 79
Th
is page displays the current settings of the AT-TQ2403 Management Software. It displays the Ethernet
(Wired) Settings and the Wireless Settings.
Ethernet (Wired) Settings
The Internal interface includes the Ethernet MAC Address, IP Address, Subnet Mask, and Associated
Network Wireless Name (SSID).
The Guest interface includes the MAC Address, VLAN ID, and Associated Network Wireless Name
(SSID).
The Port Status includes the Link Status and Link Speed in the Wire Internal Interface.
If you want to change any of these settings, click the Edit link.
Wireless Settings
The Radio Interface includes the Radio Mode and Channel. Also shown here are MAC addresses (read-
only) and Network Names for the internal and guest interfaces. (See “Setting the Wireless Interface
”
and “Configuring Radio Settings
” for more information.)
If you want to change any of these settings, click the Edit link.
Event Logs
To view system events and kernel log for a particular access point, navigate to Status > Events on the
Administration Web pages for the access point you want to monitor.
Figure 32: Status - Event Page
The
Events tabbed page allows you to enable or disable Persistence. This page also gives you the option
of enabling a remote "log relay host" to capture all system events and errors in a Kernel Log. (This
requires setting up a remote relay host first. See “Log Relay Host for Kernel Messages
”). The Events
tabbed page also lists the most recent events generated by this access point.