Filter
Top Products
248 AT-TQ2403 - Management Software - User's Guide
Note: To get a list of all properties you can set on t
he AP radio, type the following at the
CLI prompt:
set radio wlan0 [Space] [Tab] [Tab]
1. Turn the Radio On or Off
2. Set the Radio Mode
3. Enable or Disable Super AG
4. Set the Channel Policy
5. Set the Radio Channel
6. Configure Basic and Supported Rate Sets
7. Set the Beacon Interval
8. Set the DTIM Period
9. Set the Fragmentation Threshold
10. Set the RTS Threshold
1. Turn the Radio On or Off
Feature or Setting CLI Command
To turn the radio on: set radio wlan0 status on
To turn the radio off: set radio wlan0 status off
2. Set the Radio Mode
Val
id values depend on the capabilities of the radio. Possible values and how you would use the CLI to set
each one are shown below. (For information about Atheros Turbo modes see 802.11a Turbo in
Glossary.)
Feature or Setting CLI Command
IEEE 802.11b set radio wlan0 mode b
IEEE 802.11g set radio wlan0 mode g
IEEE 802.11a set radio wlan0 mode a
Atheros Turbo 5 GHz set radio wlan0 mode turbo-a
Atheros Dynamic Turbo 5 GHz set radio wlan0 mode dynamic-turbo-a