Filter
Top Products
54 AT-TQ2403 - Management Software - User's Guide
Field Description
Cluster The Cluster list at the top of the table shows IP addresses for all access points in the
cluster. (This is the same list of cluster members shown on the Cluster > Access
Points tab described in “Navigating to Access Points Management
”.)
If there is only one AP in the cluster, only a single IP address column will be displayed
here; indicating that the AP is "clustered with itself".
You can click on an IP address to view more details on a particular AP as shown in Figure
below.
A
ccess points which are neighbors of one or more of the clustered APs are listed
in the left column by SSID (Network Name). An access point which is detected as a
neighbor of a cluster member can also be a cluster member itself. Neighbors who are
also cluster members are always shown at the top of the list with a heavy bar above and
include a location indicator. The colored bars to the right of each AP in the Neighbors
list shows the signal strength for each of the neighbor APs as detected by the cluster
member whose IP address is shown at the top of the column:
Dark Blue Bar - A dark blue bar and a high signal strength number (for example 50)
ind
icates good signal strength detected from the Neighbor seen by the AP whose IP
address is listed above that column.
Lighter Blue Bar - A lighter blue bar and a lower signal strength number (for example
20 or lo
wer) indicates medium or weak signal strength from the Neighbor seen by the
AP whose IP address is listed above that column.
White Bar - A white bar and the number 0 indicates that a neighboring AP that was
detected by one of the cluster
members cannot be detected by the AP whose IP address
is listed above that column.
Light Gray Bar - A light
gray bar and no signal strength number indicates a Neighbor
that is detected by other cluster members but not by the AP whose IP address is listed
above that column.
Dark Gray Bar - A dark gray bar and no signal strengt
h number indicates this is the AP
whose IP address is listed above that column (since it is not applicable to show how well
the AP can detect itself).