Filter
Top Products
AT-TQ2403 Management Software User's Guide 271
access-poi
nt Guest, VLAN and VWN settings
ap-list AP list for rogue AP detection
bss Basic Service Set of radios
channel-planner Channel planner settings
cluster Clustering-based configuration settings
config Configuration settings
dhcp-client DHCP client settings
dot11 IEEE 802.11 (all radios)
firmware-upgrade Upgrade firmware of the AP through http
host Internet host settings
interface Network interface
log Log settings
mac-acl MAC address access list item
management Management communication configurations
ntp Network Time Protocol client
portal Guest captive portal
radio Radio
radius-user RADIUS user
serial Serial access to the command line interface
snmp SNMP (Simple Network Management Protocol)
ssh SSH access to the command line interface
static-ip-route Static IP route entry - used when DHCP is off
system System settings
telnet Telnet access to the command line interface
traphost Destination host for SNMP trap
tx-queue Transmission queue parameters
untagged-vlan Untagged VLAN configuration
vwn Virtual Wireless Network
web-server Web server
wme-queue Transmission queue parameters for stations
Example 5: Type "set mac" TAB, and the command will complete with the only matching option:
AT-TQ2403# set mac-acl
Example 6: Type "set cluster" TAB TAB, and the two matching options are displayed:
AT-TQ2403# set cluster
cluster-name Name of cluster to join
clustered Whether clustering is enabled on this node
location Location
Example 7: Type "add" TAB TAB (including a space after add) to get a list of all property options
for the add command.
AT-TQ2403# add
ap-list AP list for rogue AP detection
basic-rate Basic rates of radios
bridge-port Bridge ports of bridge interfaces
bss Basic Service Set of radios
interface Network interface
mac-acl MAC address access list item
radius-user RADIUS user
supported-rate Supported rates of radios
traphost Destination host for SNMP trap
Example 8: Type "remove" TAB TAB (including a space after remove) to get a list of all property
options
for the remove command.