Filter
Top Products
196 AT-TQ2403 - Management Software - User's Guide
Hitting TAB once will attempt to complete the current command.
If multiple completions exist, a beep will sound and no results will be displayed. Enter TAB again to
display all available completions.
Example 1: At a blank command line, hit TAB twice to get a list of all commands.
AT-TQ2403#
add Add an instance to the running configuration
factory-reset Reset the system to factory defaults
get Get property values of the running configuration
reboot Reboot the system
remove Remove instances in the running configuration
save-running Save the running configuration
set Set property values of the running configuration
Example 2: Type "get " TAB
TAB (including a space after get) to see a list of all property options for
the get command.
AT-TQ2403# get
access-point Guest, VLAN and VWN settings
ap-list AP list for rogue AP detection
association Associated station
basic-rate Basic rates of radios
bridge-port Bridge ports of bridge interfaces
bss Basic Service Set of radios
channel-planner Channel planner settings
cluster Clustering-based configuration settings
config Configuration settings
detected-ap Detected access point
dhcp-client DHCP client settings
dot11 IEEE 802.11 (all radios)
firmware-upgrade Upgrade firmware of the AP through http
host Internet host settings
interface Network interface
ip-route IP route entry
log Log settings
log-entry Log entry
mac-acl MAC address access list item
management Management communication configurations
ntp Network Time Protocol client
portal Guest captive portal
radio Radio
radius-user RADIUS user
serial Serial access to the command line interface
snmp SNMP (Simple Network Management Protocol)
ssh SSH access to the command line interface
static-ip-route Static IP route entry - used when DHCP is off
supported-rate Supported rates of radios
system System settings
telnet Telnet access to the command line interface
traphost Destination host for SNMP traps
tx-queue Transmission queue parameters
untagged-vlan Untagged VLAN configuration
vwn Virtual Wireless Network
web-server Web server
wme-queue Transmission queue parameters for stations
Example 3: Type "get system v" TAB. This will result in completion with the only matching