Filter
Top Products
232 AT-TQ2403 - Management Software - User's Guide
4. Set the Key Type
Valid values for Key Type are ASCII or Hex. The following commands set the Key Type.
Feature or Setting CLI Command
To set the Key Type to ASCII: set interface wlan0 wep-key-ascii yes
To set the Key Type to Hex: set interface wlan0 wep-key-ascii no
For our example, we’ll set the Key Type to ASCII:
AT-TQ2403# set interface wlan0 wep-key-ascii yes
5. Set the WEP Keys
Note: The number of characters required for each WEP key depends on
how you set Key
Length and Key Type:
If Key Length is 40 bits and the Key Type is "ASCII", then each WEP key is 5 characters
long.
If Key Length is 40 bits and Key Type is "Hex", then each WEP key must is 10
characters long.
If Key Length is 104 bits and Key Type is "ASCII", then each WEP Key must be 13
characters long.
If Key Length is 104 bits and Key Type is "Hex", then each WEP Key must be 26
characters long.
Although the CLI will allow you to enter WEP keys of any number of characters, you must
use the correct number of
characters for each key to ensure a valid security configuration.
AT-TQ2403# set interface wlan0 wep-key-1 abcde
AT-TQ2403# set interface wlan0 wep-key-2 fghij
AT-TQ2403# set interface wlan0 wep-key-3 klmno
AT-TQ2403# set interface wlan0 wep-key-4
6. Set the Authentication Algorithm
The o
ptions for the authentication algorithm are Open System, Shared Key or Both:
Feature or Setting CLI Command
To set Authentication Algorithm
to Open System:
set bss wlan0bssInternal open-system-authentication on
set bss wlan0bssInternal shared-key-authentication off
To set Authentication Algorithm
to Shared Key:
set bss wlan0bssInternal open-system-authentication off
set bss wlan0bssInternal shared-key-authentication on