Filter
Top Products
214
Intel
®
NetStructure™ 480T Routing Switch User Guide
Table 12.5 describes the commands used to configure the IP route
table. For more command options, press the Tab key in the
command line interface.
enable bootprelay Enables the forwarding of BOOTP and
Dynamic Host Configuration Protocol
(DHCP) requests.
enable ipforwarding {vlan <name>} Enables IP routing for one or all
VLANs. If no argument is provided,
enables routing for all VLANs that are
configured with an IP address. The
default setting for
ipforwarding is
disabled.
enable ipforwarding broadcast {vlan <name>} Enables forwarding IP broadcast traffic
for one or all VLANs. If no argument is
provided, enables broadcast forwarding
for all VLANs. To enable,
ipforwarding must be enabled on the
VLAN. The default setting is disabled.
enable loopback-mode vlan [<name>] Enables a loopback mode on an
interface. If loopback is enabled, the
router interface remains in the UP state,
even if no ports are defined in the
VLAN. As a result, the subnet is
always advertised as one of the
available routes.
enable multinetting Enables IP multinetting on the system.
Table 12.4: Basic IP Commands (continued)
Command Description
Table 12.5: Route Table Configuration Commands
Command Description
configure iproute add <ipaddress>/<mask>
<gateway> <metric>
Adds a static address to the routing table. Use
a value of 255.255.255.255 for
mask to
indicate a host entry.