Filter
Top Products
C H A P T E R 13 RIP and OSPF
245
configure ospf [vlan <name> | area
<areaid> | virtual-link <routerid> <areaid>]
timer <retransmit_interval> <transmit
delay> <hello interval> <dead interval>
Configures the timers for one interface or all
interfaces in the same OSPF area. These are the
default, minimum, and maximum values (in
seconds):
•
retransmission_interval
Default: 5 Minimum: 0
Maximum: 3,600
•
transmission_delay
Default: 1 Minimum: 0
Maximum: 3,600
•
hello _interval
Default: 10 Minimum: 1
Maximum: 65,535
•
dead_interval
Default: 40 Minimum: 1
Maximum: 2,147,483,647
configure ospf area <areaid> add range
<ipaddress> <mask> [advertise |
noadvertise] [type 3 | type 7]
Configures a range of IP addresses in an OSPF
area. If advertised, the range is exported as a
single LSA by the ABR.
configure ospf area <areaid> delete range
<ipaddress> <mask>
Deletes a range of IP addresses in an OSPF
area.
configure ospf area <areaid> normal Configures an OPSF area as a normal area. The
default setting is normal.
configure ospf area <areaid> nssa
[summary | nosummary] stub-default-cost
<cost> {translate}
Configures an OSPF area as a NSSA.
configure ospf area <areaid> stub
[summary | nosummary] stub-default-cost
<cost>
Configures an OSPF area as a stub area.
Table 13.5: OSPF Configuration Commands (continued)
Command Description