Filter
Top Products
C H A P T E R 4 Using Web Device Manager
37
Status Messages
Status messages are displayed at the top of the content frame. There
are four types of status messages:
• Information—Displays information that is useful to know prior
to, or as a result of, changing configuration options.
• Warning—Displays warnings about the switch configuration.
• Error—Displays errors caused by incorrectly configured settings.
• Success—Displays informational messages after you click
Submit. The message displayed reads,
Request was submitted
successfully
.
Stand-alone Buttons
At the bottom of some of the content frames is a section that
contains stand-alone buttons. Use these buttons to perform tasks
that are not associated with a particular configuration option. An
example of this is the Reboot Switch button.
Saving Changes
There are two ways to save your changes in Web Device Manager:
• Select Save Configuration from the Configuration task button,
Switch option.
This field contains a drop-down list box that allows you to
select either the primary or secondary configuration area. After
you select the configuration area, click Submit to save the
changes.
• Click the
Logout button.
If you attempt to log out without saving your changes,
Web
Device Manager
prompts you to save your changes.
If you select
Yes, the changes are saved to the selected
configuration area.
To change the selected configuration area:
1. Go to the Configuration task button.
2. Select the
Switch option.