Filter
Top Products
300
Intel
®
NetStructure™ 480T Routing Switch User Guide
IPX Commands
Table 16.3 describes the commands used to configure basic IPX
settings. For more command options, press the Tab key in the
command line interface.
Table 16.3: Basic IPX
§
Commands
Command Description
configure ipxmaxhops <number> Configures the IPX maximum hop count
when forwarding IPX packets. The
default setting is 16. Change this only if
NetWare
§
Link Services Protocol (NLSP)
is running in the IPX network.
configure ipxroute add [<dest_netid> | default]
<next_hop_id> <next_hop_node_addr> <hops>
<tics>
Adds a static IPX route entry in the IPX
route table. Specify:
•
next_hop_id—The NetID of the
neighbor IPX network.
•
next_hop_node_addr—The node
address of the next IPX router.
•
hops—The maximum hop count.
•
tics—The timer delay value.
You can enter up to 64 static routes.
configure ipxroute delete [<dest_netid> | default]
<next_hop_netid> <next_hop_node_addr>
Removes a static IPX route entry from
the route table.
configure ipxservice add <service_type>
<service_name> <netid> <node_address>
<socket> <hops>
Adds a static entry to the IPX service
table. Specify:
•
service_type—Srvice type.
•
service_name—Service name.
•
netid—IPX network identifier.
•
node_address—Node address of
the server.
•
socket—IPX port number.
•
hops—The number of hops (for SAP
routing).