Filter
Top Products
C H A P T E R 13 RIP and OSPF
235
OSPF Timers and Authentication
Configuring OSPF timers and authentication on a per-area basis is a
shorthand for applying the timers and authentication to each VLAN
in the area at the time of configuration. If you add more VLANs to
the area, be sure to configure the timers and authentication for the
new VLANs explicitly.
OSPF Password Encryption
The neighbor password for OSPF is encrypted in upload/download
configuration.
Route Map Support
See "Access Policies"
on page 309.
The 480T routing switch includes the ability to apply route maps to
routes that are being added to the kernel route table. You can
configure the route maps based on these origins of the route:
• Direct
• Static
• RIP
• OSPF
• BGP
These route maps match the various characteristics of the route based
on the originating protocol and set the accounting indexes. Use this
command to configure route maps:
configure iproute route-map [bgp | direct | e-bgp |
i-bgp | ospf | ospf-extern1 | ospf-extern2 | ospf-
inter | ospf-intra | rip | static] [<route map> |
none]
Use this command to view the log:
show iproute {priority | vlan <vlan> | permanent |
summary | <ipaddress> <netmask> | route-map | origin
[direct | bgp | e-bgp | i-bpg | static | blackhole
| rip | ospf-intra | ospf-inter | ospf-extern1 |
ospf-extern2]} {sorted}