Filter
Top Products
58
Intel
®
NetStructure™ 480T Routing Switch User Guide
Disconnecting a Telnet Session
An administrator-level account can disconnect a management
session that is established through Telnet connection. If this
happens, the user logged in through Telnet is notified that the
session is terminated.
To terminate a Telnet session:
1. Log in to the switch with administrator privileges.
2. Determine the session number of the session you want to termi-
nate by using this command:
show session
3. Terminate the session by using this command:
clear session <session_number>
Controlling Telnet Access
See "Using Access
Profiles" on page 59.
By default, Telnet services are enabled on the routing switch. You
can restrict Telnet access using an access profile. An access profile
permits or denies a named list of IP addresses and subnet masks. To
configure Telnet to use an access profile, use this command:
enable telnet {access-profile [<access_profile> |
none]} {port <tcp_port_number>}
Use the none option to remove a previously configured access
profile.
To display the status of Telnet, use this command:
show management
You must be logged in as
an administrator to enable
or disable Telnet.
To disable Telnet, use this command:
disable telnet
To re-enable Telnet on the switch, use this command at the console
port:
enable telnet