Filter
Top Products
238
Intel
®
NetStructure™ 480T Routing Switch User Guide
configure rip Rxmode [none | v1only |
v2only | any] {vlan [<name> | all]}
Changes the RIP receive mode for one or all
VLANs. Specify:
• none—Drop all received RIP packets.
•
v1only—Accept only RIP v1 format
packets.
•
v2only—Accept only RIP v2 format
packets.
•
any—Accept both RIP v1 and v2 packets.
If no VLAN is specified, the setting is applied
to all VLANs. The default setting is
any.
configure rip txmode [none | v1only |
v1comp | v2only] {vlan [<name> | all]}
Changes the RIP transmission mode for one or
all VLANs. Specify:
• none—Do not transmit any packets on this
interface.
•
v1only—Transmit RIP v1 format packets to
the broadcast address.
•
v1comp—Transmit RIP v2 format packets to
the broadcast address.
•
v2only—Transmit RIP v2 format packets to
the RIP multicast address.
If no VLAN is specified, the setting is applied
to all VLANs. The default setting is
v2only.
configure rip updatetime {seconds} Changes the periodic RIP update timer. The
default setting is 30.
configure rip vlan [<name> | all] cost
<number>
Configures the cost (metric) of the interface.
The default setting is 1.
enable rip Enables RIP. The default setting is disabled.
Table 13.2: RIP Configuration Commands (continued)
Command Description