Filter
Top Products
C H A P T E R 16 IPX Routing
305
The stations connected to the system generate a combination of IP
traffic and IPX traffic. The IP traffic is filtered by the IP VLANs.
IPX traffic is filtered by the IPX VLANs.
In this configuration, all IP traffic from stations connected to ports
1 and 3 have access to the IP router through the VLAN Finance. IP
traffic on ports 2 and 4 reach the IP router using the VLAN
Personnel.
Similarly, IPX traffic from stations connected to ports 4 and 5 have
access to the IPX router using the VLAN Exec. IPX traffic to port
7 reaches the IPX router using the VLAN Support. Both Exec and
Support use enet_8022 as the encapsulation type.
The IPX configuration shown in the example in Figure 16.2 uses
these commands:
create vlan Exec
create vlan Support
configure Exec protocol ipx_8022
configure Exec add port 4,5
configure Support add port 7
configure Support protocol ipx_8022
configure Exec xnetid 2516 enet_8022
configure Support xnetid A2B5 enet_8022
Displaying IPX Settings
To display settings for various IPX components, use the commands
listed in Table 16.6. For more command options, press the Tab key
in the command line interface.
Table 16.6: IPX
§
Show Commands
Command Description
show ipxconfig {vlan <name>} Displays IPX configuration information for
one or all VLANs.
show ipxfdb Displays the hardware IPX FDB
information.
show ipxrip {vlan <name>} Displays IPX/RIP configuration and
statistics for one or all VLANs.