Filter
Top Products
C H A P T E R 13 RIP and OSPF
237
BGP and OSPF Route Map Support for DSB
Accounting
Route map support for BGP and OSPF accounting allows you to set
the cost and type of the exported routes.
Use this command to enable accounting:
configure route-map <route-map> <sequence number>
[add | delete] set [as-path <as no> | community
[[access-profile <access-profile> | <as no>:
<number> | number <community> | no-advertise | no-
export | no-export-subconfed] | remove | [add |
delete] [access-profile <access-profile> | <as no>:
<number> | number <community> | no-advertise | no-
export | no-export-subconfed] |] | next-hop <ip
address> | med <number> | local-preference <number>
| weight <number> | origin [igp | egp | incomplete]
| tag <number> | accounting index <number> value
<number> | cost <number> | cost-type [ase-type-1 |
ase-type-2]]
Configuring RIP
Table 13.2 describes the commands used to configure RIP. Press the
Tab key, in the command line interface, for further command options.
Table 13.2: RIP Configuration Commands
Command Description
configure rip add vlan [<name> | all] Configures RIP on an IP interface. For each IP
interface created, RIP is disabled by default.
configure rip delete vlan [<name> | all] Disables RIP on an IP interface. When RIP is
disabled on the interface, the parameters are not
reset to their defaults.
configure rip garbagetime <seconds> Configures the RIP garbage time. The timer
granularity is 10. The default setting is 120.
configure rip routetimeout <seconds> Configures the route timeout. The default
setting is 180.