Filter
Top Products
264
Intel
®
NetStructure™ 480T Routing Switch User Guide
Use these commands to configure the parameters of the peer group.
configure bgp peer-group <peer-group> remote-as
<number>
configure bgp peer-group <peer-group> [route-
reflector-client | no-route-reflector-client]
configure bgp peer-group <peer-group> weight
<number>
configure bgp peer-group <peer-group> source-
interface [any | vlan <vlan>]
configure bgp peer-group <peer-group> timer keep-
alive <number> hold-time <number>
configure bgp peer-group <peer-group> nlri-filter
[in | out] [none | <access profile>]
configure bgp peer-group <peer-group> as-path-
filter [in | out] [none | <access profile>]
configure bgp peer-group <peer-group> route-map-
filter [in | out] [none | <route map>]
configure bgp peer-group <peer-group> [send-
communities | dont-send-communities]
configure bgp peer-group <peer-group> soft-reset
{input | output}
configure bgp peer-group <peer-group> password
<password>
configure bgp peer-group <peer-group> [next-hop-
self | no-next-hop-self]
[enable | disable] bgp peer-group <peer-group>
soft-in-reset
[enable | disable] bgp peer-group <peer-group>
When you modify the parameters, the changes is applied to all
neighbors in the peer group. Modifying the following parameters
automatically disables and enables the neighbors before the changes
take effect:
• Remote-as
• Timer
• Source-interface
• Soft-in-reset