Filter
Top Products
C H A P T E R 16 IPX Routing
301
Table 16.4 describes the commands used to configure the IPX route
table. For more command options, press the Tab key in the
command line interface.
configure ipxservice delete <service_type>
<service_name> <netid> <node_address>
<socket>
Deletes an IPX service from the service
table.
configure vlan <name> xnetid <netid> [enet_ii |
enet_8023 | enet_8022 | enet_snap]
Configures a VLAN to run IPX routing.
Specify:
•
enet_ii—Uses Ethernet 2 header.
•
enet_8023—Uses IEEE 802.3
length field, but does not include the
IEEE 802.2 LLC header.
•
enet_8022—Uses IEEE the format
and the IEEE 802.2 LLC header.
•
enet_snap—Adds Subnetwork
Access Protocol (SNAP) header to
IEEE 802.2 LLC header.
enable type20 forwarding {vlan <name>} Enables the forwarding of IPX type 20
(NetBIOS
§
inside IPX) packets from one
or more ingress VLANs. The default
setting is disabled.
xping {continuous} {size <n>} <netid>
<node_address>
Pings an IPX node. If continuous is not
specified, 4 pings are sent. The default
ping packet size is 256 data bytes. The
size can be configured to between 1 and
1,484 bytes.
Table 16.3: Basic IPX
§
Commands (continued)
Command Description
Table 16.4: IPX
§
/RIP Configuration Commands
Command Description
configure ipxrip add vlan [<name> | all] Configures one or all IPX VLANs to run IPX/
RIP. IPX/RIP is enabled by default when you
configure the IPX VLAN.