Filter
Top Products
66
Intel
®
NetStructure™ 480T Routing Switch User Guide
Displaying SNMP Settings
To display the SNMP settings configured on the routing switch, use
this command:
show management
This command displays the following information:
• Enable/disable state for Telnet, SNMP, and Web access, along
with access profile information
• SNMP community strings
• Authorized SNMP station list
• SNMP trap receiver list
• RMON polling configuration
• Login statistics
SNMP enhancements allow the ifMIB to display the port number
for physical ports and VLAN name for the VLANs index.
Authenticating Users
The routing switch uses two methods to authenticate users who
login to the switch:
• RADIUS
§
client
• TACACS+ (Terminal Access Controller Access Control System
Plus)
RADIUS Client
Remote Authentication Dial In User Service (RADIUS, RFC 2138)
allows you to authenticate and centrally administer access to
network nodes. The 480T routing switch RADIUS client
implementation enables authentication for Telnet, Web interface, or
console access to the switch.
You cannot configure
RADIUS and TACACS+ at
the same time.
You can define a primary and secondary RADIUS
®
server for the
routing switch to contact.
When a user attempts to log on to the switch using Telnet, HTTP,
or the console, the request is relayed to the primary RADIUS server,