Filter
Top Products
105
In This Chapter
Overview ................................................................................................ 105
Turning Outlets On/Off and Cycling Power ........................................... 106
Overview
The KX II allows you to control Raritan PX and RPC series rack PDU
(power strip) outlets connected to the KX II through a D2CIM-PWR.
Once a PX or RPC series is setup and then attached to the KX II, the
rack PDU and its outlets can be controlled from the Powerstrip page in
the KX II interface. This page is accessed by clicking on the Power menu
at the top of the page.
The Powerstrip page will display rack PDUs attached to the KX II for
which the user has been granted appropriate port access permissions. In
the case of tiered configurations, the Powerstrip page will display both
rack PDUs attached to the base and tiered KX IIs, for which the user has
been granted appropriate port access permissions.
Note: For information on setting up a PX, see the Raritan PX User
Guide.
From the Powerstrip page, you are able to turn the outlets on and off, as
well as cycle their power. You are also able to view the following power
strip and outlet information:
Powerstrip Device Information:
Name
Model
Temperature
Current Amps
Maximum Amps
Voltage
Power in Watts
Power in Volts Ampere
Outlet Display Information:
Name - Named assigned to the outlet when it was configured.
State - On or Off status of the outlet.
Chapter 5
Rack PDU (Power Strip) Outlet
Control