Filter
Top Products
Chapter 8: Device Management
165
Use the reset to factory defaults feature to remove the SNMP
configuration and set the KX II to its original factory default.
To reset to factory defaults:
Click Reset To Defaults.
WARNING: When using SNMP traps over UDP, it is possible for the
KX II and the router that it is attached to fall out of synchronization
when the KX II is rebooted, preventing the reboot completed SNMP
trap from being logged.
List of KX II SNMP Traps
SNMP provides the ability to send traps, or notifications, to advise an
administrator when one or more conditions have been met.
The following table lists the KX II SNMP traps:
Trap Name
Description
bladeChassisCommError
A communications error with blade chassis
device connected to this port was detected.
cimConnected
The CIM is connected.
cimDisconnected
The CIM is disconnected.
cimUpdateStarted
The CIM update start is underway.
cimUpdateCompleted
The CIM update is complete.
configBackup
The device configuration has been backed up.
configRestore
The device configuration has been restored.
deviceUpdateFailed
Device update has failed.
deviceUpgradeCompleted
The KX II has completed update via an RFP file.
deviceUpgradeStarted
The KX II has begun update via an RFP file.
factoryReset
The device has been reset to factory defaults.
firmwareFileDiscarded
Firmware file was discarded.
firmwareUpdateFailed
Firmware update failed.
firmwareValidationFailed
Firmware validation failed.
groupAdded
A group has been added to the KX II system.
groupDeleted
A group has been deleted from the system.
groupModified
A group has been modified.
ipConflictDetected
An IP Address conflict was detected.
ipConflictResolved
An IP Address conflict was resolved.