Filter
Top Products
Chapter 8: Device Management
191
5. USB profiles do not apply to Dell chassis.
6. Click OK to save the configuration.
IBM Blade Chassis Configuration
See Supported Blade Chassis Models (on page 198), Supported
CIMs for Blade Chassis (on page 199), and Required and
Recommended Blade Chassis Configurations (on page 201) for
important, additional information when configuring the blade chassis.
See Dell Chassis Cable Lengths and Video Resolutions (on page
301) for information on cable lengths and video resolutions when using
Dell
®
chassis with the KX II.
To add a blade chassis:
1. Connect the blade chassis to the KX II. See Step 3: Connect the
Equipment (on page 16) for details.
2. Select Device Settings > Port Configuration to open the Port
Configuration page.
3. On the Port Configuration page, click on the name of the blade
chassis you want to configure. The Port page will open.
4. Select the Blade Chassis radio button. The page will then display the
necessary fields to configure a blade chassis.
5. Select the IBM
®
blade chassis model from the Blade Server Chassis
Model drop-down.
To configure a IBM BladeCenter H and E:
1. If you selected IBM BladeCenter
®
H or E, auto-discovery is available.
Configure the blade chassis as applicable. Prior to configuring a
blade chassis that can be auto-discovered, it must be configured to
enable SSH connections on the designated port number (see Device
Services (on page 145)). Additionally, a user account with the
corresponding authentication credentials must be previously created
on the blade chassis. The KX II only supports auto-discovery for
AMM[1].
a. Switch Hot Key Sequence - Predefined.
b. Maximum Number of Slots - The default maximum number of
slots available on the blade chassis is automatically entered.
c. Administrative Module Primary IP Address/Host Name - Enter
the primary IP address for the blade chassis. Required for
auto-discovery mode
d. Port Number - The default port number for the blade chassis is
22. Change the port number if applicable. Required for
auto-discovery mode
e. Username - Enter the username used to access the blade
chassis. Required for auto-discovery mode