Filter
Top Products
Chapter 2: Installation and Configuration
18
2. Ensure that your target server's video is configured to a supported
resolution and refresh rate.
For Sun servers, ensure your target server's video card is set to
output standard VGA (H-and-V sync) and not composite sync.
3. Attach the keyboard/mouse connector of your CIM/DCIM to the
corresponding ports on your target server.
Use a DCIM if you are connecting from the target server video port to
the KX II.
4. Attach the CIM/DCIM to an available server port on the back of the
KX II using a standard, straight-through UTP (Cat5/5e/6) cable for
CIMs, or standard USB cable for DCIMs.
Note: The DCIM-USB G2 provides a small slide switch on the back of the
CIM. Move the switch to P for PC-based USB target servers. Move the
switch to S for Sun USB target servers. Power-cycle the CIM by
removing the USB connector from the target server, then plugging it back
in a few seconds later in order to apply the new switch position.
Step 4: Configure the KX II
For the following steps, you must change the default password and
assign the KX II its IP address at the Local Console.
All other steps can be performed from either the Local Console, or from
the KX II Remote Console via a supported web browser using the KX II's
default IP address.
Java
™
1.7 is required to use the Java-based Java-based KX II Virtual
KVM Client (VKC) and Multi-Platform Client (MPC)..
Microsoft .NET
®
3.5 (or later) is required to use KX II with the Microsoft
Windows
®
-based Active KVM Client (AKC).
Change the Default Password
The first time you start the KX II, you are required to change the default
password.
To change the default password:
1. Once the unit has booted, enter the default username admin and
password raritan. Click Login.
2. Enter the old password raritan, then enter and reenter a new
password.
Passwords can be up to 64 characters in length consisting of English,
alphanumeric and special characters.
3. Click Apply. Click OK on the Confirmation page.