Filter
Top Products
Chapter 8: Device Management
159
Configure SNMP traps on the Event Management - Settings page, which
can be quickly accessed by clicking the SNMP Trap Configuration link.
See Configuring SNMP Traps (on page 162)for information on
creating SNMP traps and List of KX II SNMP Traps (on page 165) for a
list of available KX II SNMP traps.
The events that are captured once an SNMP trap is configured are
selected on the Event Management - Destination page. See
Configuring Event Management - Destinations (on page 169).
To reset to factory defaults:
Click Reset To Defaults. All items on the page are set back to their
defaults.
WARNING: When using SNMP traps over UDP, it is possible for the
KX II and the router that it is attached to fall out of synchronization
when the KX II is rebooted, preventing the reboot completed SNMP
trap from being logged.
Configuring Modem Settings
To configure modem settings:
1. Click Device Settings > Modem Settings to open the Modem Settings
page.
2. Select the Enable Modem checkbox. This will enable the Serial Line
Speed and Modem Init String field.
3. The Serial Line Speed of the modem is set to 115200.
4. Enter the initial modem string in the Modem Init String field. If the
modem string is left blank, the following string is sent to the modem
by default: ATZ OK AT OK.