Filter
Top Products
Chapter 8: Device Management
187
13. Select the CIMs native, display resolution from the Display Native
Resolution drop-down. This is the preferred resolution and timing
mode of the digital CIM. Once a resolution is selected, it is applied to
the CIM.
If no selection is made, the default 1024x1280@60Hz resolution is
used.
14. Click OK to save the configuration.
Dell Blade Chassis Configuration
See Supported Blade Chassis Models (on page 198), Supported
CIMs for Blade Chassis (on page 199), and Required and
Recommended Blade Chassis Configurations (on page 201) for
important, additional information when configuring the blade chassis.
See Dell Chassis Cable Lengths and Video Resolutions (on page
301) for information on cable lengths and video resolutions when using
Dell
®
chassis with the KX II.
To add a blade chassis:
1. Connect the blade chassis to the KX II. See Step 3: Connect the
Equipment (on page 16) for details.
2. Select Device Settings > Port Configuration to open the Port
Configuration page.
3. On the Port Configuration page, click on the name of the blade
chassis you want to configure. The Port page will open.
4. Select the Blade Chassis radio button. The page will then display the
necessary fields to configure a blade chassis.
5. Select the Dell blade chassis model from the Blade Server Chassis
Model drop-down.
To configure a Dell PowerEdge M1000e:
1. If you selected Dell PowerEdge
™
M1000e, auto-discovery is available.
Configure the blade chassis as applicable. Prior to configuring a
blade chassis that can be auto-discovered, it must be configured to
enable SSH connections on the designated port number (see Device
Services (on page 145)). Additionally, a user account with the
corresponding authentication credentials must be previously created
on the blade chassis.
a. Switch Hot Key Sequence - Select the hot key sequence that will
be used to switch from KVM to the blade server. The Switch Hot
Key Sequence must match the sequence used by the KVM
module in the blade chassis.
b. Maximum Number of Slots - The default maximum number of
slots available on the blade chassis is automatically entered.