Filter
Top Products
Chapter 8: Device Management
144
2. If Use the Following DNS Server Addresses is selected, whether or
not DHCP is selected, the addresses entered in this section is used
to connect to the DNS server.
Enter the following information if the Following DNS Server
Addresses is selected. These addresses are the primary and
secondary DNS addresses used if the primary DNS server
connection is lost due to an outage.
a. Primary DNS Server IP Address
b. Secondary DNS Server IP Address
3. When finished, click OK.
Your KX II device is now network accessible.
LAN Interface Settings
The current parameter settings are identified in the Current LAN interface
parameters field.
1. Choose Device Settings > Network. The Network Settings page
opens.
2. Choose the LAN Interface Speed & Duplex from the following
options:
Autodetect (default option)
10 Mbps/Half - Both LEDs blink
10 Mbps/Full - Both LEDs blink
100 Mbps/Half - Yellow LED blinks
100 Mbps/Full - Yellow LED blinks
1000 Mbps/Full (gigabit) - Green LED blinks
Half-duplex provides for communication in both directions, but
only one direction at a time (not simultaneously).
Full-duplex allows communication in both directions
simultaneously.
Note: Occasionally there are problems running at 10 Mbps in either
half or full duplex. If you are experiencing problems, try another
speed and duplex setting.
See Network Speed Settings (on page 300) for more information.
3. Select the Enable Automatic Failover checkbox to allow the KX II to
automatically recover its network connection using a second network
port if the active network port fails.