Filter
Top Products
Chapter 13: KX II Local Console
277
Hot key:
Take this action:
Double Click Left Ctrl key
Press the left Ctrl key twice quickly
4. Select the Local Port Connect key. Use a connect key sequence to
connect to a target and switch to another target.
You can then use the hot key to disconnect from the target and
return to the local port GUI.
Once the local port connect key is created, it will appear in the
Navigation panel of the GUI so you can use it as a reference. See
Connect Key Examples (on page 273) for examples of connect key
sequences.
5. The connect key works for both standard servers and blade chassis.
6. Set the Video Switching Delay from between 0 - 5 seconds, if
necessary. Generally 0 is used unless more time is needed (certain
monitors require more time to switch the video).
7. If you would like to use the power save feature:
a. Select the Power Save Mode checkbox.
b. Set the amount of time (in minutes) in which Power Save Mode
will be initiated.
8. Choose the resolution for the KX II Local Console from the
drop-down list. The browser will be restarted when this change is
made.
800x600
1024x768
1280x1024
9. Choose the refresh rate from the drop-down list. The browser will be
restarted when this change is made.
60 Hz
75 Hz
10. Choose the type of local user authentication.
Local/LDAP/RADIUS. This is the recommended option. For more
information about authentication, see Remote Authentication.
None. There is no authentication for Local Console access. This
option is recommended for secure environments only.
Select the "Ignore CC managed mode on local port" checkbox if
you would like local user access to the KX II even when the
device is under CC-SG management.