Filter
Top Products
4-73
FACSIMILE
Contents
4
Specify the original size.
(1) Enter the original size.
• Touch the X (width) numeric value display key and
enter the width.
• Touch the Y (height) numeric value display key and
enter the height.
(A) To return the original size to the default size, touch
the [Size Reset] key.
(B) To automatically enlarge or reduce the image size to
the send size, touch the [Fit to Send Size] key. Do not
touch this key if you wish to scan the original at the
original size that you entered.
(2) Touch the [OK] key.
• You can also touch the keys to change the number.
• The send size is automatically selected based on the original size you entered.
• After selecting Card Shot, you can touch the [Job Detail Settings] key in the base screen and then the [Original] key
to change the original scan size or the send size. In this case, the screen of step 3 appears when you touch the
scan size key. For the procedure for setting the send size, see "Specifying the send size of the original" (page 4-49).
5
Press the [BLACK & WHITE START] key to scan the front of the card.
To cancel scanning...
Press the [STOP] key ( ).
6
Turn the card over so that the back is face down, and press the [BLACK &
WHITE START] key to scan the back of the card.
Before scanning the back of the card, you can touch the [Configure] key in the touch panel to change the exposure.
To cancel scanning...
Press the [STOP] key ( ).
7
Touch the [Read-End] key.
If you will continue by scanning the front of the card, you can touch the [Configure] key to change the exposure,
resolution, scan size, and send size.
• The ratio cannot be specified and "Rotation Sending Setting" cannot be selected.
• This function cannot be used in direct transmission mode or when the speaker is used to dial.
To cancel Card Shot...
Touch the [Cancel] key in the screen of step 4.
Special Modes
OK
OK
Cancel
Size Reset
Fit to
Send Size
Card Shot
X
Y
(25~210)
mm
(25~210)
mm
86
54
(1)
(2)
(B)(A)
X
Y
Place next original. (Pg.No.x)
Press [Start].
When finished, press [Read-End].
Read-Endconfigure