Filter
Top Products
7-102
SYSTEM SETTINGS
Contents
Network Settings
Network settings are described below. Touch the [Network Settings] key and configure the settings.
IPv4 Settings
When using the machine on a TCP/IP network (IPv4),
use this setting to configure the IP address of the
machine.
Make sure that the [DHCP] checkbox is not selected
and then select each key, enter the required values with
the numeric keys, and touch the [OK] key.
To set the machine to obtain an IP address
automatically, select the [DHCP] checkbox and
touch the [OK] key.
IPv6 Settings
When using the machine on a TCP/IP (IPv6) network,
use this setting to configure the IP address of the
machine.
Select the [Enable IPv6 Protocol] checkbox ( ).
Obtaining an IP address automatically
To set the machine to obtain an IP address
automatically, select the [DHCPv6] checkbox
and
touch the [OK] key.
When the settings are completed, the assigned state full
address and prefix length will be shown.
When settings are changed, the changes will take effect after the machine is restarted. To restart the machine see
"TURNING THE POWER ON AND OFF" (page 1-12) in "1. BEFORE USING THE MACHINE ".
• To use the machine on a TCP/IP network, the
"Enable TCP/IP" (page 7-103) setting must also be
enabled.
• If DHCP is used, the IP address assigned to the
machine may change automatically. If the IP
address changes, printing will not be possible.
System Settings
IPv4 Settings
IP Address
IP Subnet Mask
IP Gateway
OK
DHCP
System Settings
IPv6 Settings
Enable IPv6 Protocol
DHCPv6
Manual Address
OK
1/3
System Settings
IPv6 Settings
OK
2/3
Prefix Length
Default Gateway
Link-Local Address
System Settings
IPv6 Settings
Stateful Address
Stateless Address 2
Stateless Address 1
OK
3/3