Filter
Top Products
7-103
SYSTEM SETTINGS
Contents
Entering an IP address manually
To set a permanent IP address, select the [DHCPv6]
checkbox ( ).
Touch the [Manual Address] key, [Prefix Length] key,
and [Default Gateway] key, and enter the respective
values
• [Default Gateway] key
Use the numeric keys and the [A] to [F] and [:] keys on
the touch panel to enter the IP address. When
finished, touch the [OK] key.
• [Prefix Length] key
Use the numeric keys to set the prefix length. When
finished, touch the [OK] key.
• [Manual Address] key
Use the numeric keys and the [A] to [F] and [:] keys on
the touch panel to enter the IP address. When
finished, touch the [OK] key.
When all settings are completed, touch the [OK] key.
When the settings are completed, the set values will
appear in Link-Local Address, Stateless Address 1, and
Stateless Address 2
Enable TCP/IP
To use the machine on a TCP/IP network, this setting
must be enabled.
To enable this setting, select the checkbox and
touch the [OK] key.
Enable NetWare
To use the machine on a NetWare network, this setting
must be enabled.
To enable this setting, select the checkbox and
touch the [OK] key.
Enable EtherTalk
To use the machine on an EtherTalk network, this
setting must be enabled.
To enable this setting, select the checkbox and
touch the [OK] key.
Enable NetBEUI
To use the machine on a NetBEUI network, this setting
must be enabled.
To enable this setting, select the checkbox and
touch the [OK] key.
Reset the NIC
This returns all of the settings on the print server card to
the factory default settings.
Ping Command
Use this function to check if the machine can
communicate with a computer on the network.
Specify the IP address of the desired computer and
touch the [Start] key. A message will appear indicating
whether or not the computer responded.
Select each key, enter the appropriate values with the
numeric keys, and touch the [Start] key.
System Settings
Ping Command
Enter IP address via the 10-key pad and [A-F]keys,
then press[Start].
Start
A B C
D E F :
OK