Filter
Top Products
7-115
SYSTEM SETTINGS
Contents
I-Fax Settings
I-Fax Default Settings
These settings are used to configure the default settings for Internet fax.
Touch the [Image Send Settings] key, the [I-Fax Settings] key, and the [I-Fax Default Settings] key, and configure the
settings.
Auto Wake Up Print
When the [POWER] key ( ) is "off" (but the main
power switch is "on") and an Internet fax is received, this
function activates the machine and prints the fax.
To enable this setting, select the checkbox and
touch the [OK] key.
When this function is disabled, received Internet faxes
are not printed until the [POWER] key ( ) is switched
"on".
Compression Setting
This is used to set the default compression mode for
Internet fax transmission.
The settings are shown below.
•MH (G3)
• MMR (G4)
Select one of the keys and touch the [OK] key.
I-Fax Speaker Volume Settings
This is used to adjust the volume of fax receive signals
and communication error signals heard through the
speaker.
A fax receive signal sounds after the machine checks
the mail server and retrieves received faxes. A
communication error signal sounds when a delivery
failed e-mail is received from the destination Internet fax
machine.
Select one of the keys and touch the [OK] key.
Original Print on Transaction
Report
When a transaction report is printed, this is used to print
part of the first page of the transmitted original on the
transaction report. Select one of the settings below.
• Print Out All Report
• Print Out Error Report Only
• No Printed Report
Select one of the keys and touch the [OK] key.
This setting will not be effective if the following
"Transaction Report Print Select Setting" (page 7-116) is
set to "No Printed Report".
These settings can be configured when the Internet fax expansion kit is installed.
System Settings
I-Fax Speaker Volume Settings
OK
Receive Signal
Communication
Error Signal
Volume:
Small
Volume:
Middle
Volume:
Big
No Sound