Filter
Top Products
2-70
Section 2 — Control Panel Descriptions
To set the auto transition rate for all enabled levels, enter the
desired rate using the number buttons on the keypad. Pressing
three number buttons on the keypad automatically enters the rate.
If only one or two number buttons are pressed, the entry must be
completed by pressing ENTER. Rates from zero through 999
frames may be entered. (If one or two incorrect numbers have
been entered, the entry may be cleared and the previous rate
restored by pressing TRAN RATE again.)
As soon as the new rate is confirmed, it is displayed in the auto
transition rate display on the Transition subpanel of each enabled
level.
The Master E-MEM display then queries:
KEY 1 RATE = ?
This refers to the mix rate of the KEY 1 MIX buttons or DSK 1 MIX
button at the right edge of each Transition panel. To set the Key 1
and/or DSK 1 mix rate for all enabled levels, follow the same
procedure as described above for the auto transition rate. (If you
want to set each key mix rate separately, enable each level
separately.)
As soon as the new rate is confirmed, it is entered into memory for
each enabled level, but is not displayed. The display then asks for
the third rate to be set:
KEY 2 RATE = ?
Repeat the procedure again to set the mix rate for the KEY 2 MIX
buttons and DSK 2 button.
NOTE:
The mix rate for either key is displayed on the auto transition
readout when the
KEY 1 MIX/DSK 1 MIX
or
KEY 2 MIX/DSK 2 MIX
button is pressed (initiating a mix) or when the
SHOW KEY
button is
pressed on the appropriate panel and the desired key is enabled (
KEY
1/DSK 1
or
KEY 2/DSK 2
button on Keyer panel lit).