Filter
Top Products
2-74
Section 2 — Control Panel Descriptions
GET provides a method of copying or “getting” the contents of a
specified register into the Current Register.
The Current Switcher State and the Current Register number are
not affected by the Get operation.
The GET button is at low tally whenever a Get operation is
permissible and off when the operation is not permissible (when
there is no Current Register or the Current Register is locked).
When pressed, the GET button high-tallies and the E-MEM
readout provides a prompt. For example, if Bank 0 and Register 7
are currently selected, the display will prompt:
GET 0x INTO CUR
(If the bank were 1 and the Current Register 7, the display
would show: GET 1x INTO CUR)
To get the effect from a specific bank and register, change the bank
number if the correct bank is not already selected, then enter the
register number of the effect to be copied. Press
ENTER to
complete the Get operation.
The Get operation does not copy sequence link information
(sequence link register or sequence delay) to the Current Register.
An Undo of the Get operation will restore the previous contents to
the current register, without affecting the Current Switcher State
or changing the current register number.
Also, as mentioned previously under the • button description, the
GET button may be used for clearing out the Current Register by
pressing GET • ENTER.
GET