Filter
Top Products
2-77
Master Effects Memory (E-MEM) Subpanel
Modes of Insertion/Deletion
The editing mode selected determines the way keyframes are
added to or removed from an effect. The editing mode is selected
by the CONST DUR button on/off) on the E-MEM Effects Editing
panel and by the DELEGATES/ENABLES selection in the Main
Keyframe menu or the Timeline menu.
The four editing functions that add keyframes or delete keyframes
from an effect (Cut, Paste, Insert Before, and Insert After) are
affected by the selected editing mode and by the position of the
Time Cursor on the Master Timeline.
NOTE:
Cuts, Inserts, and Pastes cannot be performed on any locked
level of an E-MEM register.
Only those levels that are delegated are affected by timeline editing.
When ENABLES is selected in the Timeline menu or the main
Keyframe menu, all enabled levels are also delegated; thus all
levels are affected. When DELEGATES is selected in the menu,
only specified enabled levels are delegated; all other enabled
levels are enabled but not delegated.
With previous software versions
■ If the Master Timeline cursor was on a keyframe, an Insert
operation (Insert Before or Insert After) used the “on a
keyframe” rule; that is, a new keyframe was added before or
after the current keyframe on each delegated level, and that
added keyframe lengthened the overall duration of those
timelines.
■ If the Master Timeline cursor was not on a keyframe, the
Insert operation used the “on the path” rule; that is, a new
keyframe was added at that point-in-time on each delegated
level, subtracting the added keyframe’s duration from the
current keyframe’s duration. Therefore, the added keyframe
did not add to the overall duration of that timeline.