Filter
Top Products
2-29
Mix/Effects Effects Memory Subpanel (3000-3 Only)
NOTE:
SEQ
and LRN may be pressed in either order to start the
command sequence;
TRAN RATE
and delay, in parentheses, are optional.
TRAN RATE
enables a user-defined delay to be introduced between
register recalls;
delay
is a 1- to 3-digit number entered on the keypad that specifies an
amount of delay in TV frames. (If the number entered is a 1- or 2-digit
number, the entry must be terminated by pressing
ENTER;
register
is any desired register number, as described previously (that is,
BANK, bank number, register number).
A sequence loop may be created by again pressing the first register
button as the last register in the sequence.
Sequences are initiated by pressing the following buttons:
SEQ, register
The sequence starts at the register indicated, and proceeds
through the linked sequence to the last register. If a loop has been
programmed, the sequence loop continues until the SEQ button is
pressed to terminate the sequence.
A sequence loop can be broken by double-pressing a register
button. This clears the sequence link that existed in that register
and makes that the last register in the sequence.
Different sequence delays may be learned into the different
mix/effects E-MEM registers. With software version 3.1 and later,
these sequence delays are completely independent; thus the
sequencing may be occurring at different times on the different
M/Es.
EFF DIS causes an S-linear transition from the current state to the
next recalled register. The current state may be a setup you have
just done on the mix/effects panel or the state of the panel
resulting from a register recall.
EFF
DIS