Filter
Top Products
2-64
Section 2 — Control Panel Descriptions
The LOCK function locks a single register. Locking a register
prevents the contents of that register from being changed. To lock
the Current Register whose number is displayed, press the
following buttons:
↑, LOCK
When locked, an “L” is displayed at the left end of the
E-MEM readout, next to the register number. To unlock the
register, press the buttons again:
↑, LOCK
NOTE:
You cannot lock an entire E-MEM bank from the subpanel; a
menu selection is provided for this action. (Refer to the E-MEM Menu
description in the Menu section of this manual.)
Pressing the BANK 0 button makes Bank 0 the current bank, and
causes buttons 0 through 9 on the keypad to become one-button
recall registers for registers 00 through 09. This button is lit
whenever bank 0 is the current bank.
Pressing BANK 1 makes Bank 1 the current bank, and causes
buttons 0 through 9 on the keypad to become one-button recall
registers for registers 10 through 19. This button is lit whenever
Bank 1 is the current bank.
ENTER confirms a numerical entry on the keypad, such as for the
following functions: GET, PUT, KF DUR, GO TO TIME, GO TO KF,
and TRAN RATE. The ENTER button lights when pressed. (The
TRIM function of this button is not implemented at this time.)
SEQ is used for creating automated register-recall sequences.
BANK
LOCK
LRN
BANK
0
BANK
1
TRIM
ENTER
SEQ