Filter
Top Products
2-65
Master Effects Memory (E-MEM) Subpanel
Sequences are created by pressing the following buttons
(parameters in parentheses are optional):
SEQ, LRN,
register, TRAN RATE, delay,
register, TRAN RATE, delay,
...
NOTE:
SEQ
and
LRN
may be pressed in either order to start the
command sequence;
TRAN RATE
and
delay
, in parentheses, are optional.
TRAN RATE
enables a user-defined delay to be introduced between
register recalls;
delay
is a 1- to 3-digit number entered on the keypad that specifies an
amount of delay in TV frames. (If the number entered is a 1- or 2-digit
number, the entry must be terminated by pressing
ENTER
;
register
is any desired register number, as described previously (e.g.,
BANK
,
bank number
,
register number
).
A sequence loop may be created by again pressing the first register
button as the last register in the sequence.
Sequences are initiated by pressing the following buttons:
SEQ, register
The sequence starts at the register indicated, and proceeds
through the linked sequence to the last register. If a loop has been
programmed, the sequence loop continues until the SEQ button is
pressed to terminate the sequence.
A sequence loop can be broken by double-pressing a register
button, which clears the sequence link that existed in that register
and making that the last register in the sequence.