Filter
Top Products
2-72
Section 2 — Control Panel Descriptions
Effect Editing Controls
The effect editing controls are located in the upper portion of the
Master E-MEM subpanel.
The CLEAR WORK BUFR, GET, and PUT buttons on the effect
editing panel are at low tally whenever they are enabled to
perform their respective functions.
All other buttons on the effect editing panel must be enabled
by a menu selection in the main Keyframe menu. (Select
ENABLE with the KEYFRAME EDITING soft button.)
When enabled, the effect editing buttons are at low tally;
when disabled, the effect editing buttons are off. (Some of
the buttons may also be off under certain conditions, as
described under the individual button descriptions.)
CLEAR WORK BUFR is used to restore user-defined default
switcher state values to the Working Buffer, clearing out any
previous values that were stored there. This button is normally
off, but lights for one-half second when pressed.
CLEAR WORK BUFR is always functional, even when the other
effects editing buttons are not enabled (KEYFRAME EDITING set to
DISABLE
in the Keyframe menu).
NOTE:
The “Current Register” is defined as the active register on each
E-MEM level. If all enabled levels are in the same register, the Current
Register is the same as that shown in the E-MEM keypad display.
However, if the enabled levels have different Current Registers, as
indicated by a “
∆
” between the bank number and the register number, the
Get and Put operations will operate on different registers. For example,
if enabled level M/E 1 is in Register 1, and enabled level M/E 2 is in
Register 2, a “PUT CUR INTO 03” operation will copy M/E 1 Register
1 into M/E 1 Register 3, and M/E 2 Register 2 into M/E 2 Register 3.
CLEAR
WORK
BUFR
MOD
PASTE
INSRT
BEFOR
GO
TO
TIME
PUT
MARK
KF
DUR
CONST
DUR
EFF
DUR
GET
MARK
CURSR
TIME
CURSR
PREV
NEXT
INSRT
AFTER
MARK
BLOCK
COPYCUT
GO
TO
KF
CLEAR
WORK
BUFR