Filter
Top Products
2-97
Wipe Subpanel
Pattern Mix
PATT MIX toggles the pattern mix mode on or off. When PTN MIX
SOURCE
is set to NORMAL in the menu, the pattern mix mode
causes the delegated wipe generator to mix its pattern with the
other wipe generator pattern on a given M/E. (The “other wipe
generator” is the secondary generator if delegated to the primary,
or the primary generator if delegated to the secondary.) When PTN
MIX SOURCE
is set to TEXTURE, the pattern mix mode causes the
delegated wipe generator to mix its pattern with the texture
pattern.
The adjacent PATTERN MIX knob controls the mix ratio between
the two pattern generators. If the PTN MIX TYPE is NAM+ or
NAM- (as selected in the Wipe Modifier menu), the pattern mix
knob controls the relative size of the two patterns. The knob value
(shared by mix and NAM modes) is remembered when the PATT
MIX
button is turned off.
Wipe Direction
NORM and REV select the wipe direction (normal or reverse). One
of these buttons is always on.
FLIP FLOP toggles flip-flop mode on and off. When flip-flop mode
is on, the wipe direction changes at the end of each wipe
transition. (The NORM and REV lights alternate on and off during
a wipe, every time the transition reaches the opposite limit.)
NOTE:
The
NORM
,
REV
, and
FLIP FLOP
buttons on the Wipe subpanel
do not affect the primary preset pattern key. Instead, a menu selection
provides a choice of either
NORM
or
REV
.
PATT
MIX
PATTERN MIX
REV
NORM
FLIP
FLOP