Filter
Top Products
2-120
Section 2 — Control Panel Descriptions
2. With one of the BUS DELEGATE buttons, select the (physical)
AUX BUS (1-4) that you want to use. With the switcher set up
as described previously for non-looping, the DPM output will
be routed to the previously-mapped crosspoint column on the
Source Select panel.
3. Select the Keyer output to be sent to the DPM by pressing one
of the AUX 1-4 EFFECTS SEND ONLY buttons on the
PVW/AUX row of buttons (M/E 1B through M/E 3 KEY 2).
NOTE:
The
B
and
A
bus selections apply only when in layered mode.
4. On the Source Select panel, select the DPM output on the aux
return that has been mapped to one of the crosspoints, as
described earlier. This may then be selected as a source on any
output bus on the Source Select panel.