Filter
Top Products
2-27
Mix/Effects Effects Memory Subpanel (3000-3 Only)
Mix/Effects E-MEM Readout
The alphanumeric readout at the top of the E-MEM keypad
provides status information about E-MEM operations and
registers.
During normal learn and recall operations, the display informs
you what the current Bank (“B...”) and Register (“R...”) are. If the
register is locked, there is an “L” shown at the left end of the
display. Other messages on the E-MEM readout include “NO
REG” at bootup, and “NO EMPTY” if no register is available for a
LRN •
operation.
≠/BANK is a two-function key that can be used for bank selection
or for accessing “second” functions, for example, LOCK and
UNDO
. Pressing the ≠/BANK button enables single-digit bank
selection (0 through 9) on the keypad, and delegates buttons with
second functions to the second function. The button lights when
pressed, and stays lit until the delegation is completed. Pressing
↑/BANK
a second time terminates the delegation.
Refer to the “Learn and Recall Operations” description earlier in
this section for use of the BANK button, and to the LOCK and
UNDO headings for use of the ↑ (second) function button.
LRN is used for storing or “learning” the current panel setup into
a register or for learning a register sequence.
Refer to the “Learn and Recall Operations” description earlier in
this section for learning effects into E-MEM registers. Also refer to
the SEQ button description for learning a register sequence.
The LOCK function locks a single register. Locking a register
prevents the contents of that register from being changed. To lock
the current register whose number is displayed, press the
following buttons:
≠, LOCK
L B0 R04
BANK
LOCK
LRN
BANK
LOCK
LRN