Filter
Top Products
2-44
Section 2 — Control Panel Descriptions
Matte Delegation
Each Matte subpanel has a MATTE SEL button used to select which
of the six matte generators that particular subpanel will control.
Above the MATTE SEL button are six indicators, which illuminate
to show the current delegation at any given time. Pressing the
MATTE SEL
button repeatedly cycles the selection through all six
matte generators. Holding the button down causes it to cycle
through the selections automatically until the button is released. If
the Borderline option is not installed in Key 1 or Key 2, the
K1 BORD and/or K2 BORD selections will be skipped.
MATTE SEL Indicators
The six indicators above the MATTE SEL button indicate
delegation as follows:
K1 FILL and K2 FILL LEDs—Indicate that the Matte subpanel is
delegated to one of the matte generators for an area determined by
the key hole cutter. However, when the keyer is in Video Fill
mode, the matte is not visible. All key types (LIN, LUM, CHR, PST
PTTN) are operational with matte fill.
K1 BORD and K2 BORD LEDs—Indicate that the Matte subpanel is
delegated to a matte generator for adjusting the characteristics of
the key border matte in all Borderline modes. (See the Keyer
subpanel description for related keyer buttons BORD, SHDW,
EXTRUDE
, and OUTLINE.)
PRI WIPE LED on the M/E Matte subpanel—Indicates delegation
of the matte generator for controlling the transition wipe border
matte. The PRI WIPE LED also indicates that the M/E Matte
subpanel is delegated to create the primary preset pattern border
in preset pattern mode. (See the PRI PST PTTN button description
under the Keyer subpanel description.)
MATTE
SEL
K1 FILL K1 BORD
K2 FILL K2 BORD
PRI WIPE SEC WIPE
M/E Mattes
Panel