Filter
Top Products
2-28
Section 2 — Control Panel Descriptions
When locked, an “L” is displayed at the left end of the
E-MEM readout. To unlock the register, press the buttons again:
≠, LOCK
NOTE:
You cannot lock an entire E-MEM bank from the subpanel; a
menu selection is provided for this action.
Pressing the BANK 0 button makes bank 0 the current bank, and
causes buttons 0 through 9 on the keypad to become one-button
recall registers for registers 00 through 09. This button is lit
whenever bank 0 is the current bank.
Pressing BANK 1 makes bank 1 the current bank, and causes
buttons 0 through 9 on the keypad to become one-button recall
registers for registers 10 through 19. This button is lit whenever
bank 1 is the current bank.
ENTER confirms a numerical entry on the keypad, such as for
TRAN RATE. The ENTER button lights only when pressed.
SEQ is used for creating automated register-recall sequences.
Sequences are created by pressing the following buttons
(parameters in parentheses are optional):
SEQ, LRN,
register, TRAN RATE, delay,
register, TRAN RATE, delay,
...
BANK
0
BANK
1
TRIM
ENTER
SEQ